New Experiment Of Making A 12 Volt Diy DC Motor From Scratch

  Today We Learn About How To make A 12 Volt Diy DC Motor From Scratch Full Prosses Using Iron Plate, wire no 28 and magnet Step by step

1- First of All we will cut a round or circle shaped piece of an metal like iron Shown below

2- Now we will clean it and make drill holes in this plate or iron and after this it will look like the below image

3-Now we will Cut a small part from every hole for passing wire like shown in below image 

                                                      

4-Now we have to use a shaft like shown in below image 

5-Now we have to fic this shaft in the center then this will look cool like shown in below image

 

6- This will be a break time because I am tired (hahahahahahha) just a joke now back to work we will select a wire of 28 number  for winding and wind 70 rounds each like the below image

7-Now after 70 rounds of wire then give a round to shaft like the below image

8- Do This for all at end final results are shown below

9- You need meganets like shown below

10- Fix the motor like shown below

11- Final step is to connect wires and run the motor 

SO THIS IS THE FINAL RESULTS THANKS FOR WATCHING AND FOR FULL VIDEO VISIT OUR YOUTUBE CHANNEL OR WATCH BELOW

OR VISIT OUR YOUTUBE CHANNEL:  MULTI ELECTRO