1 operation mode selection.
used for switch over between operator control operation mode and control circuit terminal control mode.
2 menu
used to select one of the 5 modes.
3 esc
return to the previous status.
4 shift/reset
used for constant value selection when setting the constants
it is used for fault reset when fault occurs.
5 access
press this key to decide the mode' constant'setting.
6 increment
used for changing constant code and setting. (increment)
7 decrement
used for changing constant code and setting. (decrement)
8 for/rev
press this key to change the motor's speed direction when the
operation is controlled by operator.
9 run
press this key to start the inverter's operation when the inverter
is controlled by operation .run will be on at this time.
10 stop
press this key to stop the inverter's operation when the inverter
is controlled by operator. stop will will be on at this time.it can
be enable or disable by constant 02-02 when the inverter is
under terminal control.
No comments:
Post a Comment